Ford E4od Transmission Rebuild Manual The C6 core components were used to build ford's 1st electronically controlled automatic transmission. The e4od was introduced in 1989 and used in both light and ...
A/T - E40D No Upshifts or Harsh Upshifts/4th Gear StartsNotesTECHNICAL BULLETIN # 230A TRANSMISSION: E4OD SUBJECT:
No upshift 4th gear starts, harsh upshifts, neutrals out after shifts APPLICATION: Ford-E/F Series, Bronco DATE: Jan 1995 E4OD No Upshifts, 4th Gear Starts, Harsh Upshifts, Neutrals Out After Shifts All of these concerns can be the result of an inappropriate Manual Lever Position (MLP) sensor signal.The MLP sensor consists of six resistors connected in series (ganged).The resistance of the MLP sensor will vary based on which range the transmission is in.The MLP circuit can be checked using the following steps.(Step 1) Check the MLPS ground: Turn the ignition on.
The voltage on pin 46 (sensor
Page 1 of 3ALLDATA Online - 1994 Ford Truck F 350 2WD Pickup V8-7.3L DSL Turbo VIN F - ...) should not exceed .1v.If the voltage is excessive, add an additional ground to the existing ground wire (figure 2).Figure 2 Splice an additional ground from the existing ground wire to a known good ground.The negative post of the battery is the best
This view is of the pins of the MLP connector pins.(Step 2) Check the MLPS voltage: The voltage at pin 30 should vary-in increments- according to the position of the manual lever (figure 3).MLP voltage (ignition on) should be within 20% of these specifications.
Page 2 of 3ALLDATA Online - 1994 Ford Truck F 350 2WD Pickup V8-7.3L DSL Turbo VIN F - ...
It is recommended that you use a break-out box.If a break-out box is not available, you will need to pierce the wires to pins 30 and 46 for these tests.(Step 3) Check the resistance of the MLPS: The resistance of the MLPS (pins 30 and 46) should change-in increments-with the position of the manual lever (figure 4).Note If this test is being done with a break-out box, disconnect the computer first (make sure the ignition is off).
If this test is being done without a break-out box, disconnect the MLPS from the vehicle harness.REVISED This is a revised bulletin.
Remove bulletin 230 from your files.Note Testing beyond this point will include tests of the harness.
Consult the appropriate repair manual for this.
Page 3 of 3ALLDATA Online - 1994 Ford Truck F 350 2WD Pickup V8-7.3L DSL Turbo VIN F - ..